Avalon Pellet Stove Problems

Pellet Stove. Horizontal Or Vertical Vent. Freestanding Stove. Mobile Home Approved. Class A Chimney Retrofit. Hearth Stove into Existing Masonry Chimney, Masonry Fireplace, or Z.C. Fireplace Tested and Listed by Omni-Test Laboratories, Inc. Portland, Oregon Report # 028-S-42-2 ASTM E1509-2004. I have had this pellet stove for 4 years now and I only use the super premium quality pellets. Dry creek most of the time and when I run out if that and use the blend garbage it shuts down on me. Best pellet stove next to the Harman p68. Haven't had a problem ever. I highly recommend this brand. Thanks for letting me share. A pellet stove can have performance problems caused by the amount of air inside the stove. Adjusting the air intake can fix some performance issues. 1 Observe the flames inside your wood pellet.

Stove

Avalon Pellet Stove Problems E2

It’s not uncommon for people to think of the worst case, most expensive scenario when their pellet stove is not working correctly. Sometimes thinking the control board is bad on a pellet stove is little more than a guess and usually just jumping to conclusions. I get a lot of calls from people thinking they have a bad control board on their pellet stove and seven out of ten times it’s something else.

How to know if the control board on your pellet stove is bad. Usually when the control board fails on a pellet stove the stove just won’t do anything. This accounts as the symptom for 90% of all control board failure. At this point people are looking for a blown fuse or something else less worse but usually if nothing is turning on it’s a bad control board.

A slightly less common symptom is if one of the components on the pellet stove is not turning off or turns on/off erratically. It’s very unusual but you can have a relay fail on a circuit board and get stuck “on.” But usually when something is not turning off it is just the low limit sensor that has gone bad.

If you are turning a knob up and down and there is no change in motor speed or fuel feed and it use to change before, that is probably a bad control board problem.

If you have a Whitfield Traditions or Whitfield Profile 20 or Profile 30 that is not feeding properly or stops feeding for no reason you should first replace your Photo Eye and if that does not fix the problem then replace or have the control board repaired.

Avalon Pellet Stove Dealers

My company does repair pellet stove control boards and we sell new boards too. Just go to eBay and search for your brand stove and the word “repair” and if we fix that brand you’ll see a listing show up where you just simply read and follow the instructions on how to have your board repaired.